Preparing the Site for a Driveway

Posted on by — 1 Comment ↓

Before they could start putting in our new driveway they had to prepare the site.

Cutting Through the Contrete on the Old Driveway The first step for this was to cut away the old driveway and remove it. Because of the height difference between the old driveway and the garage they only cut away the first half of the drive.

As you can see in the photo on the left they made followed a very systematic approach to cutting up the old concrete. They made pretty quick work of it too using the concrete saw.

Removing the Old Driveway with a BobcatIt became clear why they were so precise with the cutting up of the driveway when the bobcat arrived the next day. It probably only took the bobcat about 15-minutes to remove the concrete driveway pieced and drop them into the skip that was delivered.

They then used the bobcat to flatten the area down a bit before dumping a few cubic metres of gravel roadbase / crackadust down and levelling it off. This will provide the base that the concrete will be poured onto when that gets delivered tomorrow.

Our Finished Open Tread Staircase

Posted on by — 2 Comments ↓

Our Open Staircase with Metal Frame and Timber TreadsI had a comment from a friend that in the last photo that I took of the staircase you couldn’t actually tell that it was an open tread design for the stairs. They were a bit surprised about what it looked like when they saw it in person.

So here is a photo I just took of the staircase from below. You can much more easily see how the open tread design looks.

The area under the stairs will make for some great storage, but because of the open treads we will have to make sure to keep them nice and tidy.

One thing about the rich colour of the stairs is that they make for some great photo opportunities with the kids …

Kids on the Stairs

Owner Builder fined $1500 for no Licence

Posted on by — Leave a reply

In some recent inspections of building sites around Townsville the inspectors issued three fines to people doing work without the proper licence. This is a reduction from the last time that they did the inspections of licences when they fined a lot more people for improper licensing.

All three of the people fined for not having the appropriate licence were all working on the same owner builder’s building site.

The owner builder himself did not have an owner builder’s license. An owner builder license is required for any work where the total material and labour cost would exceed $15,000 if done by professionals. The owner builder course is a relatively short course that I had to do before starting the work on our house.

There were two other carpenters working on the same house that were also fined for not having the appropriate license for the work they were doing.

To avoid getting fined for improper licensing of tradespeople you should make sure to do the following:

  • Check the license of any and all contractors that you hire
  • Always check if you need a license before starting any building, renovation of home improvement projects. Even a seemingly small project like putting in a shed requires council approval in some parts of Australia (including Townsville)

If you are unsure about any of the licensing, and if your contractor does have the proper license it would be worth giving a call to the local building authority. Here in Queensland you can check out any licensed trades person on the BSA web-site as long as you have their license number.

How Much Does a Driveway Cost

Posted on by — 1 Comment ↓

We are getting a new aggregate driveway put in when we replace our existing driveway. As we looked at what to do with our driveway, how much of it to replace and what sort of driveway we were going to get put in cost obviously played a part in making our decision.

To get our new aggregated driveway installed over our existing driveway, including removing portions of our existing driveway and preparing the site, will cost about $85.00 per square metre.

My wife was always been a big fan of the aggregated driveway, and the cost difference between it and a regular driveway is negligible. Here in Townsville it seems to be the most popular type of driveway to put in with new homes being built in the older areas, or in the new areas.

I have heard aggregated driveways also called "pebblecrete", because it looks like pebbles on top of concrete.